东日电气销售热线
·Postion:Home > Soft Start Control Cabinet for ESP Unit
点击查看前一组产品
  • 点击查看“VFD Control Cabinet for ESP Unit”的相关信息 点击查看“Medium Voltage VFD Control Cabinet for ESP Unit”的相关信息 点击查看“Soft Start Control Cabinet for ESP Unit”的相关信息 点击查看“ESP Control Cabinet”的相关信息 点击查看“Motor Controller for ESP Unit”的相关信息
  • 点击查看“VFD Control Cabinet for PCP”的相关信息 点击查看“Self-Compensating Control Cabinet for PCP”的相关信息 点击查看“Intelligent Protection Controller for PCP”的相关信息 点击查看“Evacuation-Proof Protection Device for PCP”的相关信息 点击查看“Name”的相关信息
  • 点击查看“Intelligent VFD Control Cabinet Special for Rod Pumping Unit”的相关信息 点击查看“Intelligent VFD Control Cabinet for Cluster Well”的相关信息 点击查看“Self-Compensating Control Cabinet for Pumping Unit”的相关信息 点击查看“Self-Compensating Controller for Pumping Unit”的相关信息 点击查看“Name”的相关信息
  • 点击查看“Echometer and Dynamometer System”的相关信息 点击查看“Automatic Controller for Echometer”的相关信息 点击查看“Echometer System”的相关信息 点击查看“Portable power tester for oil well”的相关信息 点击查看“Insulation resistance tester for ESP system”的相关信息
  • 点击查看“Low Capacity Hydraulic Rodless Pump”的相关信息 点击查看“Name”的相关信息 点击查看“Name”的相关信息 点击查看“Name”的相关信息 点击查看“Name”的相关信息
  • 点击查看“Automatic Test System for ESP Unit”的相关信息 点击查看“Electric Induction Drying Equipment for ESP Unit”的相关信息 点击查看“Cable test equipment for ESP”的相关信息 点击查看“Cable repair holder for ESP”的相关信息 点击查看“Name”的相关信息
  • 点击查看“Cable clamp”的相关信息 点击查看“Cable Protector”的相关信息 点击查看“Cable Protector”的相关信息 点击查看“Cable Protector”的相关信息 点击查看“Cable Protector”的相关信息
  • 点击查看“Name”的相关信息
点击查看后一组产品
Introduction Recommend Contact us

    QYRK series of soft start switchboard for electric submersible pump (ESP) unit, developed by Dongying Orientsun Electric Co. Ltd., with the functions of soft start and soft stop as well as the wireless communication, can not only protect ESP unit, prolong the operating life, also meet the remote control requirements for ESP unit.

Features
1.Reduce the starting current. When soft starting, the starting current of unit is decreased from 5-6 times of full voltage to 2 times of that. The reduction of the starting current can protect the cable, extend its operating life, as well as lower the huge mechanical impact on unit in full voltage starting mode greatly, and then reduce the shaft broken failure due to the mechanical impact.

2.Eliminate the over-voltage. When soft stopping, the working voltage of motor is declined from rated value continuously, it can eliminate the damage to cable insulation due to 3 - 4 times over-voltage produced by full voltage stop. This function can protect aged motor cable and reduce the damage rate greatly.

3.Reduce the unit damage due to the sudden power failure. With built-in surge arrester, the switchboard can reduce over voltage from the precious 3-4 times to 1.5 times around, which can reduce the unit damage greatly due to the over voltage produced by power failure.
4.By-pass installation. Switch to by-pass installation when soft starter broke down, which can insure the normal operation.
5.* Anti-reverse protector. The fluid discharging in tubing string may cause high-speed reversion of ESP as the check valve fails. If starting up at this time, the enormous impact resulted by high starting current of motor will damage the unit. The anti-reverse protector may refuse the motor startup and therefore effectively protect the ESP unit from damage.
6.Under-load delay auto-start function. The unit will soft stop if the under-load time exceeds the setting time. The soft starter will automatically soft start the motor if turn on the under-load delay auto-start function and delay to the setting time.
7.Developed functions of protection and ESP fault diagnosis of upper computer software. It functions to protect the overload, under-load, short circuit, default phase, three-phase current unbalance, the over-voltage and under-voltage. The controller is equipped with USB port, and the electrical parameters saved in the controller can be uploaded to computer with flash drive and generate four curves of average voltage and three-phase current. The upper computer software is attached with ESP fault diagnosis system to help managers analyze and judge ESP faults.
8.Power detection and single well electricity metering function. All parameters can be set on LED display. The readout parameters include three-phase voltage, three-phase current, active power, reactive power, apparent power, power factor and 175 events log, as well as accumulated electricity consumption and that of the day before.
9.Default phase and phase discrimination protecting functions. The ESP unit will refuse to start up and display on the screen when the phase sequence of power supply has default phase or wrong connection.
10.* Ground auto-alarm function. The switchboard will automatically send the alarm signal when the unit grounding.
11.* Online detection and display of the insulation resistance of ESP unit.
12.* Remote control function.
*Optional functions as requested by users.
In conclusion, the soft-start switchboard for ESP unit developed by our company can not only extend the operating life and pump checking period, but also save the comprehensive cost of the pump. Above advantages of the product is distinguished from the common ESP switchboard.

 
  

 

Hits:4388  Entry Time:2016/1/7 【Print】 【Close
东日联系方式
CONTACT
Add:No. 69 Dengzhou Road Dongying City Shandong Province, China
Tel: 86-546-8056451 86-546-8056448
Fax: 86-546-8056447
Mobile No.:+86 13705468224
All Rights Reserved: Dongying ORIENTSUN ELECTRIC CO., LTD 鲁ICP备06011675号-1